Applying a pure solution in this form is not very nice, because it will be poorly equalized, and it is difficult to rub it on this brick wall. Its applicability can be used using a reference special cone, which is suspended by the rope, and at the very beginning it is sharp, and at the end expanding, it allows you to seize the risks on it itself. If a hollow brick, in its composition, can occupy no more than 7-8 centimeters, then for full brick, this will be 14-16 centimeters.
Work with the solution
And it is necessarily mixed before use. That this special cone is. The mass of this cone is 300 grams, 180 millimeters in height, and the diameter of its base is 150 millimeters, the angle at its top is -30%. Usually every 10 millimeters risks are strung in height.
When lowering this cone into a solution of cement mass, it begins to sink, and at the same time we notice that this solution is suitable for simple brick, with its immersion by 13 centimeters. Therefore, we begin the masonry of this solution on the brick wall. When laying the walls with a brick, it is applied according to certain parameters, this will be called a dressing of seams, which in turn are transverse, longitudinal, or vertical.
The ligation system
Usually use single -row or multi -row tuning systems. A single -row system allows you to use pale and spoon rows of masonry, and in a multi -row dressing, tech are laid through several spoon rows. A grid is laid between them, very with small steps, which allows its applicability to use in high -rise buildings, or a simple metal wire, which will be fixed through four to five rows of brick, and and and in different places.
If the use of this wire makes a slightly difficult process of work, then in the future, this will enhance the masonry itself. On this, we, perhaps, will finish discussing these examples of laying brick on the walls. A large number of reasoning was expressed on this subject, but still these examples, rendered good applicability in many places, ranging from the extreme south to the north.