Many people today install panels in the kitchen. It should be noted that this business is quite difficult and it is necessary to approach its implementation with a special mood. Most questions arise when fixing the panels on the apron. Plastic panels for the apron are large sheets of a laminated chipboard of a rectangular slab, which has a smaller thickness compared to the countertop.
The best option for the “apron” is a plate with a thickness of 3-10 mm. There must be a film of the same color on its surface. If there is a drawing on the countertop, then on the tiles it should also be present. This “apron” is quickly installed. Among the advantages you can highlight an acceptable price. Installation of the wall panel in the apron area in the kitchen is quite simple.
First fix the wall panel in the right place of the wall. For these purposes, you can use liquid nails. Quite often, the panels are fixed with dowels, nails should have a size of 6×60 or 6×40, on the wall. Then they can be closed with decorative hats-losers in accordance with the color of the panel. You can easily remove the upper edge under the shelf. To fix the lower edge of the wall panel, use a skirting board, which is also called a parietal side. It must be fixed on the countertop using self -tapping screws. Thus, you will securely fix the wall panel.
The corner should have color corresponding to the color of the panels that are combined. The corners have a golden and silver color good. They are great for the color of the handles in the kitchen or the rails. You can hide the joint seams between the panels with corners. In addition, it does not allow the crumbs to be under kitchen tables. It is better to use rails in the kitchen, they can help in additional fastening the panels to the wall.
There is also another method for a flat wall, on which you plan to install a panel in which it can be placed on the tabletop of the headset. Due to which it will be pressed from above by boxes, with below is fixed with a baseboard. The upper cabinets of the headset should be located on the panel, higher than two cm. You don’t need to glue anything. When dismantling, you do not have to tear off the panel from the surface of the wall.