An integral attribute in a private house is water. Therefore, lack of water leads to the following problems, for example, the installation of a shower or washing machine. Therefore, there is a great desire to spend water inside the house.
Time does not stand still and progress moves forward, so the absence of hot water in the house is no longer a problem, you just need to install a water heater. Moreover, in our time there is a very large selection of such devices, for this it is enough to contact a specialized store and make your choice.You should also not think that it is very expensive to spend water in a private house.The cost will depend on your taste and the equipment company. There are two sources of water: a well and a well. Which type of sources you would not choose, without a powerful pump, you will not do. If there is a central water supply near your house, then picking up it is the perfect option.
How to conduct water supply in a private house
Before you start any work, you need to coordinate everything with the water utility. If the ditch in which water pipes will be located crosses the road, then you should get permission from the local traffic police, and also coordinate the scheme of the place of work with them. After you are completing the processing process, you need to restore the road surface, all this you do at your own expense.
You should purchase the following materials: sewer pipes, connecting couplings, metal -plastic pipes, a sink with a mixer. If the central water supply is held underground, then for the installation of a well, purchase reinforced concrete rings and a metal cover.
If the water supply is not far from your home, within two to three meters, you can dig a ditch and manually, or call a tow truck. The ditch must be digging beyond the level of freezing of the soil, about 1.8 meters.
Otherwise, we will inevit the rupture of the pipes if you do not dig a ditch of the indicated minimum, since your pipes cannot withstand seasonal temperature differences. And these are additional costs and problems. If you have the central highway to be above the ground, then after you pick up the bare sections of the pipe from the ditch to the highway, you should carefully heat. In case of underground communications, the soil should be very carefully digging in the place where the central water supply passes, so as not to damage the pipe. In this place, in order to freely have access to wiring and you should put reinforced concrete rings. If you do not have such rings, you can replace them with car tires. Also do not worry if you will soon find water in your well, it can be rain, melt or groundwater.
How to conduct water supply in a private house
After you complete all the preparatory work, you can start laying the water tube. Most people make their choice on a twenty millimeter diameter of a metal -plastic tube. It is convenient to use and does not rust, here is its main advantages.
Carefully compile the base under the body, otherwise it is possible to draw the base, which in the future can lead to rupture of the pipes. If the pipe is under the roadway, it should be laid in the sleeve, since due to the loads from the transport the integrity of your water supply can be violated.
To break through the foundation, use a metal pipe with a cork, it should be pierced in the lowest place of the ditch. A metal tube is needed to prevent flattening the end of the pipe. After all the work is finished, you must fall asleep back to the ground. The soil must be filled up taking into account the shrinkage. Usually, in order to fill in the ditch, they use crushed stone of the middle fraction.