In any repair, the ending of the ceiling chandelier is considered the final stage. The operation to install it requires self -confidence and minimal knowledge of electrical engineering. To do this, get the lamp you like, prepare the necessary tools and you can safely get down to business.
You will need it
– punch;
– ladder;
– Kusachki;
– block for the clamp of the wires;
– indicator screwdriver;
– screwdriver;
– insulating tape;
– Plary hugs in which isolated handles.
Brief instruction
1. Prepare a hook for hanging a chandelier. If there are no holes, then do it using a perforator in the center of the ceiling. It should be near the place of exit of the wires. Attach the hook to the ceiling with an anchor method, and then wrap it with an insulating tape in 2 layers.
2. Study the instructions for the chandelier for the correct installation. It is important what type of chandelier you chose, in the Axioma Light Studio, a large selection of Zonca lamps, despite the fact that the manufacturer is one – the design of the chandelier may vary. If it is indicated in the instructions that grounding is required, consider this during installation.
3. De -energize the room with machine guns in an electric shield. Using the indicator, check carefully when the absence of the switch is turned on in the mounted voltage network. Having checked, translate the switch to the “off” position.
4. You can start installation. Remove a little insulation from the wires and dilute the ends to the sides. The bare wire along the length should be 3-5 mm. Find two phase and “zero” wires. The phase goes to the switch, and zero in the box.
5. Serve the voltage on the wires and once again check the wires with the indicator. Place with insulating tape zero wire.
6. Install where phase wires on the lamp. Usually there is a marking on chandeliers. Three working wires are usually laid in the tube and displayed on the terminals on the mounting block. The block then hides at the lamp under the decorative cartridge.
7. If there is no marking, then turn on in turn in the socket two of any wires extending from the lamp, not touching the 3rd. Когда половина ламп загорится, пометьте изолентой включенные провода. Leave one in the outlet, and install a batch of the 2nd third wire there. If the other half lit up, then they found a second phase wire. The wire that remained during the operation in the outlet is “zero”.
8. Carefully hang a chandelier on the hook. Connect the “zero” wire with the same on the ceiling. Connect in the same way and phase. Do not connect aluminum and copper wires with rations, use special clamps.
9. After finishing the wires, set the decorative cartridge in place, but so that the clamping block and wires are hidden. Support and make sure that the chandelier burns and everything is connected correctly.