In the life of every person, just like this or for the need, the question arises of which to tie a sea knot. The methods of such a node are different. For example, a flat marine node is most often used if necessary to knit any ropes, one rope should be thicker than another. In order to make it easier to tie the ropes, it is necessary to lay out on a flat surface. First, one rope must be folded in the form of a loop, then the other rope should be placed under the loop made and laid out on top of the indigenous end of the rope.
How to tie a sea knot
Lay the thin rope over the loop of Tolstoy, but the ends to draw under it. So it turns out the same loop as the thick rope. The remaining ends of the bound ropes must be fixed. The next method called the fishing bayonet. Here you need to tie the end of the rope twice in the scum, tie the indigenous part, then stick it into the resulting loops, and tighten. With the method of a sliding bayonet, the tip of the rope must be tied around what you tie, make a cross on the cross of the slag, tied around the pillar, for example, and make a cross on the cross of the slag again. The Kalmyk sea node is done as follows: make a loop, then make the knot with the end of the rope at the very end of the loop, then put down the end of the rope and go into the same unit at the end of the loop. Brashmkotnaya sea node tie the tip of the rope into a loop and pass under the indigenous part of the rope. The strand method is done as follows: tie the loop made around the pillar and the indigenous area of the rope and tie it around the Shegla, which is on the pillar. With a ward node, you need to make a loop and tie it around the jack and tie the indigenous part.
How to tie a sea knot
There are many ways to tie a sea node, but they are all used for a certain load. For example, for a heavier cargo, you need to use stronger nodes and strong ropes. For the use of the side node, you need to tie a knot, make loops and make them in different directions, below the knot should be under the object, and the loops should be tied from the sides. There is also a second method of tying this node: make a loop, and the items that need to be fixed should be installed on the place where the ropes intersect, and the other end of the rope is crossed over the object, and tied it, after pulling into the loop, thus, the second loop will turn out to be a second loop. This second loop should be divided into the sides, and make it under the hack.